How do you replace a rear windshield motor on a 1996 oldsmobile bravada?

1. REMOVER WIPER ARM FROM SHAFT AS FOLLOWS,



A. PUT WIPER ARM ASSEMBLY IN PARK POSITION, THEM REMOVE HOSE ASSEMBLY ELBOW FROM FROM HOSE CONNECTOR.



B. REMOVE CAP, THEN THE NUT FROM ARM ASSEMBLY.



C. REMOVER WIPER ARM ASSEMBLY FROM SHAFT.





2. REMOVE NUT AND SPACER FROM SHAFT, THEN THE INTERIOR FROM VEHICLE LIFTGATE.



3. DISCONNECT THE BATTERY GROUND, THEN THE CONTROLLER ELECTRICAL CONNECTOR.



4. REMOVER WIPER MOTOR SCREWS, THEN THE WIPER MOTOR FROM THE VEHICLE.



5. DISCONNECT THE WIPER MOTOR HARNESS FROM THE CONTROLLER, THEN REMOVE CONTROLLER FROM THE WIPER MOTOR.



6. REVERSE TO INSTALL, NOTING THE FOLLOWING.



A. POSITION MOTOR ON VEHICLE WITH SCREWS, WHILE KEEPING SHAFT CENTERED IN LIFTGATE HOLE, TORQUE WIPER MOTOR SCREWS TO 57 INCH POUNDS.



B. TORQUE SHAFT NUT TO 53 INCH POUNDS.How do you replace a rear windshield motor on a 1996 oldsmobile bravada?
pain in the azz.. i suggest taken it to a shop that specialize in doing that.. or to the dealer