Tuesday, September 13, 2011

I need to replace a car antenna that is on the top of the windshield pillar. How do I run the new wire down?

Tie a string onto the radio end of the antenna wire, then remove the antenna from the pillar. Tie the new antenna wire radio end to the string and pull the string through the pillar down to the radio. Use some electrical tape to help secure the knot in your string and to help keep it from getting caught on uneven edges.I need to replace a car antenna that is on the top of the windshield pillar. How do I run the new wire down?
attach it to the old one and pull it thru. good luck,you only have 1 chance at this,so tape it with good tape.I need to replace a car antenna that is on the top of the windshield pillar. How do I run the new wire down?
The windshield pillar has a trim panel inside near the glass that is held in with a couple screws. Take out the screws and pry off the panel carefully. there sits the antenna and the wire!
  • AJAX in .net
  • printer keep jamming
  • No comments:

    Post a Comment

    Note: Only a member of this blog may post a comment.