Thursday, September 22, 2011

Windshield Wiper stop return to vertical position instead of horizontal?

I have a 1985 S-10 Blazer, I bought a windshield wiper motor to replace the old bad one. This one, everything works fine except when switched off, the wiper return to vertical instead of horizontal. Since there are only 4 wires into the unit, is there a way to correct this problem by just cut and rewire the external wires?Windshield Wiper stop return to vertical position instead of horizontal?
Wiper park switch is bad.

It tells the motor what to do.



http://www.shop.com/CHEVY_CHEVROLET_BLAZ



DONT reposition the wiper arms!!!! You will break something.!!



1985 CHEVROLET BLAZER 5.0L 305cid V8 4BBL (H) : Wiper %26amp; Washer : Wiper Motor Pulse Board Module



AIRTEX Part # 6H1384

w/Intermittent WipersWindshield Wiper stop return to vertical position instead of horizontal?
you may be able to reposition wipers on the nut be sure not to bind up the motor though
Oops sounds like the wiper are has slipped on it's drive shaft.



Take a spanner and remove the window wiper, reposition it in the parked position and tighten the nut again

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.